Warwick Streamer Stage I NT five string, wide neck bass (2002) :: Second Hand Bass Guitar Stock, used, pre-owned :: For sale, UK, Warwick, Bass Direct, Birmingham, London, Manchester, USA

 


<Previous bass | Next bass>


Warwick Streamer Stage I NT wide neck bass (2002)

£1799 + £12 UK shipping


  1. Please contact the shop to pay by Bank Transfer or finance

  2. Please contact us for international shipping rates

  3. Second hand 2002 bass presented in superb condition, low fret wear, great action and features a clean, flame maple body and a wenge fingerboard. The instrument has been fully cleaned and set up and comes with a hard case. The bass has just benefitted from a pro set up, and has had a replacement nut fitted and an East U Retro Deluxe preamp installed (details below)

  4. (2021 list £4599)

  5. Weight: 9lb 12oz/4.4kg

  6. Actual bass shown - please click on images to enlarge;













Specifications;

Flame maple body

Natural oil finish

Flame maple through neck

Wenge fingerboard

34" scale 24 fret

19mm string spacing at bridge

Graphite nut

wenge f/b

MEC pickups

East U retro Deluxe 3 band eq (switches inside cavity)

Weight: 9lb/4kg


U Retro Deluxe Preamp


The U Retro's high quality circuit uses three stacked knobs and includes an active blend circuit plus a 3 band equaliser with bass, variable frequency mid, treble and bright function. A passive tone circuit is also included which operates in both active and passive modes.

A very gentle built in contour gives immediate colour without detracting from the basic sound of any bass. The active blend circuit prevents the loss associated with many passive basses where, when both pickups are up full, the signal from one pickup feeds into the other and vice versa.

However, a switch is included to allow a passive equal mix of both pickups. A second switch - basic "get-you-out-of-trouble" passive mode is included in case the battery dies in crucial circumstances, but this mode allows lots of useful settings too.

A standard PP3 battery is used to power the U Retro.


Technical

VOLUME & BLEND (Knob stack nearest the neck pickup)

VOLUME
The upper knob is the Volume which has two sections under the same knob. A high impedance for the passive path and a low impedance section is used for the active circuitry. When used active, this knob has active circuitry after it so that the feed to your amplifier is a low impedance drive.

BLEND & PICKUPS SWITCH
The lower outer knob is the Blend balance for the pickups. Turn it fully clockwise for the neck pickup alone and fully anti-clockwise for the bridge pickup. The midway position, which has an indent, gives an equal mix of both pickups. The balance between the pickups is continuously variable with progressive level compensation towards the single pickup settings. Important:- The Pickups switch (by the blend) must be set pointing towards the jack for the Blend to function.

BASS & TREBLE (The middle knob stack)

TREBLE (+12dB @ 3 kHz, -12dB @ 1kHz)
The upper knob is the Treble control with boost and cut. The central 'flat' position is indented. The cut settings work on lower frequencies compared to boost to give a deeper sound when the top is rolled off.

BRIGHT (+8dB @ 7kHz)
Pull the Treble knob for the Bright setting.

BASS (+15dB @ 50Hz)
The lower outer knob is the boost only Bass control. The frequency band of boost gets progressively lower as the boost is increased. An indent midway is included to aid the setting of this control.

MID LEVEL & FREQUENCY (The knob stack nearest the jack)

BOOST/CUT (+/- 12dB)
The upper knob controls the amount of Mid boost or cut at frequencies according to the setting of the Frequency knob. The midway indent is the 'flat' position.

FREQUENCY (150Hz - 3kHz)
The lower outer knob is continuously variable and sets the Mid frequencies for boost or cut.

PASSIVE TONE
The passive tone pot consists of two sections, one for each pickup. Two sections are necessary since the pickup signals are kept separate and fed to their own individual input amplifiers prior to the electronic blend circuitry.

To retain the characteristics of a true passive tone, its circuitry is connected directly to the pickups at all times and therefore function in both active and passive modes. The roll-off frequency is set to give a deep mellow sound.

ACTIVE PASSIVE SWITCH (By the jack)
Towards the jack for active, the opposite for passive.


 


Tel: 01926 886433








Nine months interest free credit on up to £2000 on Instrument purchases! For UK residents aged between 16 and 25.